Tutorial using the Envelope Punch Board

Using the Envelope Punch Board you will need a piece of Designer Series Paper or Cardstock 5" x 5".

Line your paper on the left side at the 2" mark on the ruler up top. Then punch and score.

Turn your paper one time and line your paper on the left side at the 3" mark on the ruler up top. Then punch and score.

Turn your paper one time and line your paper on the left side at the 2" mark on the ruler up top. Then punch and score.

Turn your paper one time and line your paper on the left side at the 3" mark on the ruler up top. Then punch and score.

 This is what your DSP or cardstock will look like when you are done punching and scoring.

Fold all 3 sides leaving one of the short 2" sides not folded this is the top where your treat will go in.

 Adhere the 3 folded sides with sticky strip to stay secure. Slide your snack size candy bar or whatever treat that will fit in your treat holder.

Embellish the outside however you would like to.  I used the stamp set Very Merry Tags.
If you have any questions email me at tammybstampn@att.net.

Halloween Treat

This treat holder was made using the Envelope Maker.

You start with a piece of cardstock 5" x 5".

You put the cardstock in the envelope maker and the left side is to measure 2" then punch and score. Rotate the cardstock 1 turn and measure 3" then punch and score. Rotate the cardstock 1 turn and measure 2" punch and score. Rotate to the last side of cardstock measure 3" punch and score. Fold 3 sides leaving one of the small sides without a fold this is the top when the treat slides into. Adhere the 3 sides and embellish.  I may try to come up with a tutorial next week so come back and check it out.